Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
jowihue:lights [2017/09/12 15:33]
wim
jowihue:lights [2018/03/07 20:04] (current)
wim
Line 15: Line 15:
 Also you can configure to recover the last known settings after powering off (by using a switch for example) a lightbulb on this tab. It will take a bit before the plugin discovers a light being reachable again, so at first the light will start with the default settings and after a few seconds the light will be reset, if this option has been set. Also you can configure to recover the last known settings after powering off (by using a switch for example) a lightbulb on this tab. It will take a bit before the plugin discovers a light being reachable again, so at first the light will start with the default settings and after a few seconds the light will be reset, if this option has been set.
  
-{{ :​images:​lights_detail.png |}}+{{ :​images:​lights_detail.png|}}
  
 The plugin will refresh all values automatically. You can set the refresh frequency on the configuration page. The optimal refresh rate will depend on the speed of your network and the number of lights you are using. If refresh rate is set too high, you might see the root device status regularly change to "​unreachable"​ while seeing the bulb itself still responding to other signals. ​ The plugin will refresh all values automatically. You can set the refresh frequency on the configuration page. The optimal refresh rate will depend on the speed of your network and the number of lights you are using. If refresh rate is set too high, you might see the root device status regularly change to "​unreachable"​ while seeing the bulb itself still responding to other signals. ​